Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,We noticed today that while the SIP200 OIR events are sent to the local logs (buffered), they are not sent to our syslog servers, as the rest of the systems messages.The missed message was something like:SLOT 1: Feb 17 13:53:29: %SPA_OIR-6-...
Hello all,i have a dnis-based dial-in vpdn configuration on my LAC and need to add 10 consecutive dnis numbers to this group.Any way to make a single wildcard entry to do it, instead of 10 separate entries? All my attempts to use a dial-peer like pat...
Hi, i have link problems since i replaced a 7200 with PA-E3s with a 7600 with SIP/200&SPA-4XT3/E3. The perfectly working link with 7200, never goes up/up with the SPA. Also the SPA does not recognize a hardware looping (cable). Tried 2 SPA modules. I...
Is there a way to view the received clock rate when using a WIC-1T?The command "show controllers serial" provides the info for the NM and PA modules but the output for the WICs is more cryptic...
Hi,Just use the appropriate serial PA card (PA-E3 or PA-T3). Configure the link as any other serial link.Regarding the ATM, i think that the creation of a point to point subif would be the simplest solution, but my ATM knowledge is limited Chris.
Hello,The old 3500-XL is L2 only and unable to support the functions you mentioned. The latest IOS for this is the 12.0.5WC11 if i remember correctly...
Hello Jason and thanks for the prompt reply.command:show controllers serial 1/1 (PA-4T i/f running at 1024 Kbps)line state: upcable type : V.11 (X.21) DTE cable, received clockrate 1023606What i am looking for is the eqiv. of this info for the WIC ...
