Received clockrate and WIC-1T
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-06-2004 03:21 AM - edited 03-02-2019 04:51 PM
Is there a way to view the received clock rate when using a WIC-1T?
The command "show controllers serial" provides the info for the NM and PA modules but the output for the WICs is more cryptic...
- Labels:
-
Other Networking
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-06-2004 05:12 AM
I am 99% sure that you can not determine the clockrate coming into a serial interface for the cisco routers. I have never seen it in my testing but I hope someone out there has and provides us with that detail. The best bet has always been using a test set.
Jason Smith
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
07-06-2004 05:36 AM
Hello Jason and thanks for the prompt reply.
command:
show controllers serial 1/1 (PA-4T i/f running at 1024 Kbps)
line state: up
cable type : V.11 (X.21) DTE cable, received clockrate 1023606
What i am looking for is the eqiv. of this info for the WIC intefaces.
Chr.
