Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I'm using CCM 4.1.3 my voice gateway is connected to PSTN ISDN. Autoattendant is working fine on-Net, but not working over PSTN, it always give a busy tone.Any help?Tks
HiWhen i try to configure the gigabit interfaces, at the promt:switch(config)#interface ?Does not show any Gig interface. the system have sys and RPS Led amber.Note: the sytem was working fine.Please help.
Switch#sh ver Cisco IOS Software, C2970 Software (C2970-LANBASE-M), Version 12.2(25)SEB2, RELEASE SOFTWARE (fc1)Copyright (c) 1986-2005 by Cisco Systems, Inc.Compiled Tue 07-Jun-05 21:19 by yenanhROM: Bootstrap program is C2970 boot loade...
Hi Jake,Use Filtering by mac address, and use Data radio encryption ( WEP) and choose "full encryption". This will allow only bridges with same WEP key to associate.RegardsMariano