01-04-2006 11:31 AM - edited 03-03-2019 01:19 AM
Hi
When i try to configure the gigabit interfaces, at the promt:
switch(config)#interface ?
Does not show any Gig interface. the system have sys and RPS Led amber.
Note: the sytem was working fine.
Please help.
01-04-2006 12:07 PM
Can you paste output of
sh ver
sh post
sh env all
01-06-2006 08:54 AM
Switch#sh ver
Cisco IOS Software, C2970 Software (C2970-LANBASE-M), Version 12.2(25)SEB2, RELE
ASE SOFTWARE (fc1)
Copyright (c) 1986-2005 by Cisco Systems, Inc.
Compiled Tue 07-Jun-05 21:19 by yenanh
ROM: Bootstrap program is C2970 boot loader
BOOTLDR: C2970 Boot Loader (C2970-HBOOT-M) Version 12.1(14r)EA1a, RELEASE SOFTWA
RE (fc1)
Switch uptime is 1 hour, 34 minutes
System returned to ROM by power-on
System image file is "flash:c2970-lanbase-mz.122-25.SEB2/c2970-lanbase-mz.122-25
.SEB2.bin"
cisco WS-C2970G-24T-E (PowerPC405) processor (revision L0) with 118784K/12280K b
ytes of memory.
Processor board ID CAT0928Y0FJ
Last reset from power-on
The password-recovery mechanism is enabled.
512K bytes of flash-simulated non-volatile configuration memory.
Base ethernet MAC Address : 00:14:F2:9C:FF:00
Motherboard assembly number : 73-8754-08
Power supply part number : 341-0048-03
Motherboard serial number : CAT09280DUS
Power supply serial number : DTH09262JMA
Model revision number : L0
Motherboard revision number : A0
Model number : WS-C2970G-24T-E
System serial number : CAT0928Y0FJ
Top Assembly Part Number : 800-23385-05
Top Assembly Revision Number : A0
Hardware Board Revision Number : 0x01
Configuration register is 0xF
!!! WARNING: The switch is not usable !!!
01-07-2006 04:56 AM
Switch#sh env all
FAN is FAULTY
TEMPERATURE is OK
POWER is OK
RPS is NOT PRESENT
01-07-2006 05:52 AM
It looks like a faulty switch to me. In the show version output the bit after the 'Processor Board ID' should list the interfaces on the switch. I have a 3750 and it looks like this:
Processor board ID CAT090XXXXX
Last reset from power-on
3 Virtual Ethernet interfaces
48 FastEthernet interfaces
4 Gigabit Ethernet interfaces
The password-recovery mechanism is enabled.
I also have a 3550 and the output is slightly different but it still lists the ports under that section.
Raise a call with Cisco and get it replaced.
HTH
Andy
01-07-2006 08:56 AM
Hi,
as a last try erase all config, config-register 0x2102 and reload.
In any case it reports a faulty fan. So I would also guess that the switch needs to be replaced.
Hope this helps
Martin
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide