Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have been trying to make SIP calls from my Cisco 5300 RTR terminate to my ISP ( TATA) but still can’t get it to work call are getting disconnected after first Ring. Below are the equipment Involve. E0 ...
Hi all, I am trying to set up a DHCP Ipv6 server, but when I connect my machine to the network My machine is not getting and IPv6 address neither the DNS address. If I statically configure an Ipv6 address on my machine I am able to ping my default Ga...
Hi,I want my computer with an IPv6 Address of the block 2800:410:890:1::/64, reach both IPv4 and IPv6 address ( I don't want to use an ipv4 address on my cumputer). I configured and enable NAT_PT for IPv6 on my router. I cannot ping 2800:410:890:1::...
Hi,I have two tunnels set up with Hurricane Electric for our IPV6 connection; the problem is that tunnel 10 is constantly dropping; this is the configuration I am using on my BGP router.ipv6 unicast-routinginterface Tunnel9 description Hurricane Elec...
HI Vinay Sharma, we got a couple of cisco 1552E and I want to convert the to Autonomous. I downloaded the Ios from Cisco "c1520-k9w7-tar.153-3.JAB" Did the steps you mention:I configured my TFTP server on my Laptop.# debug capwap console cli XXX 2n...
HI Vinay Sharma, we got a couple of cisco 1552E and I want to convert the to Autonomous. I downloaded the Ios from Cisco "c1520-k9w7-tar.153-3.JAB" Did the steps you mention:I configured my TFTP server on my Laptop.# debug capwap console cli XXX 2n...
Hi Aokanlawon,Yes, calls are working without "PRACK"Below is the configuration I used but I am sure the ITSP did some changes on thier side, becuase this is the same Configuration I was using when we started the SIP Trunk connectionit never work and...
Hi Aokanlawon,Finally the calls are Terminating succesfully. It had to do with the "PRACK" as you mensioned earlier. I called the ITSP at fisrt they were requesting the "PRACK" but then they disable that option on thier end,and they Never Informed...
Hi Aokanlawon,I disable the " PRACK" using ( no rel1xx require "100rel") and made a TEST calls but still the calls are Disconencted.. Below is the debug cccsip messages I obtained.SIP Call messages tracing is enabledBZE-AGGR-RAS03#BZE-AGGR-RAS03#B...
