About misscat123

misscat123 · 12-19-2014

Hi, I have appox 8 locations on L2L with one ISA500 at main office.(ISA both ends) Whenever a remote...

misscat123 · 11-18-2014

Thank you Thank you Thank you. Saved me from pulling my hair out. Yesterday I could not figure out w...

misscat123 · 11-04-2014

Hi Aleksandra,I was able to get only partial config from the switch. There were errors on trying to ...

misscat123 · 10-29-2014

I'm not sure how to do that since the device is menu driven, or http only. No command line on this s...

misscat123 · 10-28-2014

Hello, even though this post is over 5 years old, it helped me today! However, when I tried to chang...

misscat123 · 05-22-2014

Hi,I'm wondering if the 5508 wlan controller can send me notifications of wap up/down conditions? I'...

misscat123 · 12-24-2013

Thanks for your answer. that makes sense to me.

misscat123 · 12-13-2013

Hi,I have a question about static nat statement and the IPS module. Customer says that there was a b...

misscat123 · 10-18-2013

Anybody? I'm having this error, cannot download the config, getting errors. Firmware version 1.3.0.6...

misscat123 · 08-02-2013

Hi, thanks for your response.I opened a case with Cisco Small Business support, and the tech told me...

misscat123 · 08-01-2013

Hi,I wonder if there is a way to set 100% of bandwidth to an IPSEC tunnel? I was told by CSB support...

misscat123 · 07-31-2013

So, if I may comment, because I am having the exact same problem. And I too had CSB support team on ...

misscat123 · 07-23-2013

Thank you for the clear explanation!

misscat123 · 07-19-2013

Hi,I have a Cisco ISR2921 router. I want to be able to SSLVPN to the box from the internet. It is un...

misscat123 · 10-22-2012

All great suggestions. I appreciate the input. I've checked user devices and found the iPhone is at ...

Cisco ISA500 Site to Site tunnels need to be manually reset on failure