Hello everybody,
I have 1000V (or similar) router which has legs using subinterfaces in 10 or more VLANs. The intended deployment is LISP mobility by stretching subnets to multiple locations and IPSEC/SSL VPN accessing these VLANs from Internet.
...
Hello everybody,
Hope you can point me to the right direction. I am trying LISP after my original attempt of extending L2 with IPSec/L2TPv3 did not work with 1000v.
I have being trying to setup PoC using 1000v on central site and 892 on a remote ...
Hello
I am looking into more complicated SSL VPN deployment with Cisco 1000v. Here are details
1000v as SSL VPN for multiple projects/network1000v will have VLAN interface on each network, but will not act as default gatewayEach network VLAN has it...
Hello everybody,
I came into realization that our deployment of extending L2 with L2TPv3 inside IPSec does not work with 1000v cloud services router.
Background of the deployment:
Purpose of the current architecture and restrictions - extending L...
Setup/background:
2504 WLC: 3 interfaces connected, 2 in use, three 2700 AP.
Interface 1 on WLC is management and as well used for WLAN P700. Here is the switch port config connecting to port 1
interface GigabitEthernet1/0/9 switchport access vla...
Hello Victor,
First of all thanks for such a detailed document.
May I ask for a help? I am trying to setup LISP ESM subnet extension solution. I am using following white paper documentation as a reference:
http://www.cisco.com/c/en/us/products/c...
Hello,
I am looking into more complicated deployment. Here are details
1000v as SSL VPN for multiple projects/network1000v will have VLAN interface on each networkEach network VLAN has its own DHCP serverUser authentication needs to be done against...
Pieterh,
Thanks for reply. After several trial and errors here is the config what made it work.
- DHCP proxy is disabled globally
- I added 192.168.1.1 in the WLAN config, Advanced section, as DHCP server
- I added IP helper for interface VLAN70...
I's say - if if L2TPv3 tunnel is up and passes traffic (this is your case) then problem is most likely outside. In my case L2tpv3 tunnel was not passing traffic.
You need to look at the traces at various entry/exit points and see what exactly is hap...
