Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, For several months, we have noticed slowness in CIFS transfer from two sites via the DMVPN.I tried everything without success, change of operator link, change of switch, the link is not overloaded.Change MTU (1450)..Any suggestions pleasethank...
Hello,
I would like to configure the policy-map in the interface tunnel GRE for allow only 20 MBPS and drop exceed-action , but it not work :
Policy-map policer_rate_20M
Class class-default
Police 20000000 3750000 conform-action transmit excee...
hello,
I need your help to mount an IPSec VPN between LAN 1 and 2 Lan, Lan in 2 there are 3 firewalls (FW1---NAT-t --- FW2), but the FW 3 which worried me, do you have any comments or suggestions about this project (see attachement)
thanks
Hi,
Can anyone tell me if it is better to use the auto qos on catalyst 4510R+E Sup7
thanks in advance
auto qos voip trust
SW-2960-POE <-------- Gi9/1 - Catalyst 4500 - Gi9/6 ---> BABX
interface GigabitEthernet9/1 switchport trunk native vlan 100 swi...
Hello,
Please can anyone could tell me if the QOS configuration is valid.
Is possibly help me with the corrected
Thanks
Telephone IP ----------Gi1/0/1 SW-2960X-POE Gi1/0/48 -------------------- Gi9/1 Catalyst 4510R+E Gi9/6 --------------------...
Hello Joseph,We had bypasse the encryption device, and tried many transfer CIFS with this configuration tunnel belowthe BW site A :200Mthe BW site B :400MThere is not congestion or saturation during the test transfer Site Ainterface Tunnel123descript...
Hello, We had try to change value MSS and MTU without succes.The slow transfere still present,Below configuration tunnel : interface Tunnel124vrf forwarding VRF124ip address 10.2.158.12 255.255.255.248no ip redirectsip mtu 1500ip nhrp authenticatio...
Hello Marce,Thank you for your help, I will try this values MTU/MSSEveryting is ok, IPSLA tcp connect corect ( 21ms), ,no errors on interfaces.The only issue is slow tranfer CIFS :PC (test)<->Switch<->Router<->Mistral(devide encryption) <->Router pro...
Hello Paul,Thank you for your helpEveryting is ok, IPSLA tcp connect is correct ( 21ms), ,no errors on interfaces.the only issue is slow tranfer CIFSPC (test)<->Switch<->Router<->Mistral(devide encryption) <->Router provider<->MPLS<->Router provider<...
HI,Many thanks for your suggestionFYI, We already tried change the value MTU in the tunnel addressip mtu 1500IP MTU 1400We also changed the MTU of the laptop (windows test) to 1450 without improvement.
