Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a need for a floating static route or a Virtual Stack solution.We are currently using a pair of wireless radios, for redundancy, to service a large site with no local LEC services.The switches terminating the wireless radios on the dock are s...
Good afternoon,Looking for any advice on my issues. We have a pair of C9300L-48P-4X-A at our core and three compact 9200CX and one 9200L-48. We swapped out a pair of 3750v2 and the other older 3750 and 2960 switches and had no issues prior to the swa...
I could use some help from the community on this weird issue.Please see the design attached.Setup:We have a 200Mbps connection through our internet provider. We have a Juniper switch at the core with a Cisco 4331 router ver 16.9.4, A Fortigate firewa...
We are looking to upgrade from a NEXUS 5548UP pair and 2 pair of 2248 FEX's. I have kept aside 6 pair of 10G ports to connect to our new switch infrastructure.
We really like the NEXUS 93180LC-EX pair running NX-OS as a new core with 93180YC-EX and ...
Good afternoon,
I'm having issues just enabling exception crashinfo. I have a 3750x stack that reboots randomly every few months or so. I have the 3750x stacked with 3750v2's and they are all running the same version(Version 15.0(2)SE8) I was hoping...
We ended up finding the issue.We had set the arp timeout to 5 on the SVI.We had been setting on 3750's without issues for years but certainly was an issue on these 9k's.We swapped over to Juniper EX line back 8 years ago and just dusted off the old t...
Good morning Leo,I was on a call with one user at the site and had some packet loss during the call. He said we was still seeing some lag in his email application this morning but didn't notice the voice packet loss. The office has a fairly early sta...
I have the commands you mentioned in place and all is good for all non FEX ports.
The FEX trunk itself shows Jumbo frames are enabled BUT I can't
version 7.0(3)I7(2)
policy-map type network-qos jumbo class type network-qos class-default mtu 9216
...
