Hi All, I have a small setup below. I want to hide all traffic from Host A so i configured static NAT on my corp router. After configuring static NAT i couldn't ping the remote router IP. If i remove NAT ping works fine. Host A ( 192.168.1.10) --->...
Hi, We have cisco 4507 catalyst switch in which end users are connected. today this catalyst switch goes down , i checked the input power was normal but the Switch is not running. All the notification lights like supervisior engine and Fan status...
Hello engineers, our customer has a cisco 3750 router in which they configured PAT for internet access. Total 500 users are sharing the 4 Mbps internet line ,Most of the time performance of internet access is good. But today the users are compla...
Hello everybody, we are using NAM traffic analyzer 4.0 in our network . i want to capture packets flowing in and out of a particular interface of switch. Is it possible ?
Hi Tyson Joachims, Below find the Corp rtr config. Remote rtr is not under my management.Another information i want to share is the host A can able to communicate with Host B sucessfully with NAT. only issue is from router i can't ping the remote rt...
Hi Tyson,Below find the config for Corp RTR. Remote rtr is not managed by me so not possible to share. Additional info which i missed to put in original post is that The Host A can able to talk with Host B successfully. Issues is only from corp ro...
I am trying to disable mop on cisco ISR 4431 router interfaces running version 16.9.4 but the command is not recognized. Hope this feature is not supported by latest routers / SW versions . ISR4431(config)#int GigabitEthernet0/0/0ISR4431(config-if...
.jpg "VIP Advisor"){kind=icon}
