Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Got idsm in a 6500. Too much traffic causing the load to go to 100%. Is there away to skip traffic to certain inbound destinations from getting inspected? I'm not talking about Event Action Filters as those don't stop the inspeciton, but just turn of...
Hi,I have OCHCC and OCHTRAIL created between two OTU2_XP cards. The OCHTRAIL is in IS state. The OCHCC is still in OOS state. Both sides show major alarm for the client port SIGLOSS Signal Loss on Data Interface. I know for sure that one side has the...
According this this excellent document on page 68 it says that it's recommended not to enable Aggressive UDLD on any ports, keep default Normal UDLD on fiber ports, and enable Normal UDLD on copper ports. Would anyone disagree with this recommendatio...
Joseph, can you please confirm if this would work:1. No MDS and no 5K2. VNX5300 direct FCoE attached to 6248UP3. FIs are in FC switch mode4. FIs are not in Ethernet switching mode5. Zoning is not needed, all hosts have access to all FC targetsJust wa...
LOL, sure, I'm going to take an advice for an opinionated cisco training instructor. Ivan is a smart guy, no question, but he does't deal with real world situations.
Reza, thank you! So just to confirm I can have vPC Layer 2 VLANs extended across those two links, and at the same time two Layer 3 non-VPC VLANs with one VLAN on one link and another VLAN on another link with Layer 3 SVIs on two sides peering EIGRP, ...
