Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I currently have a nexus 5010 with 10gb hosts and fiber attached storage at location A. At location B, I have an additional nexus 5010 with 10gb host with a CNA that will be using fcoe to connect to storage. I'd like for the host at location B to con...
I have 4 AIR-LAP1522AG-A-K9 raps in proximity of each other. Each RAP has it's own ethernet connection on the wifi vlan. One of the raps connects on the vlan, however, the 3 other RAPs connect to the first rap as their parent AP and don't use the eth...
I have an ASR1002 with up links to 2 different ISP's. There is a 200Mbps connection to ISP A and 65Mbps to ISP B. I am receiving full BGP routes from both ISP's. What is the best way to load balance between the asymmetric links? Thanks
On a 6513 running 12.2(18)SXF5 I am getting the following errors in the log:May 23 15:09:11 edt: %MCAST-SP-STDBY-6-GC_LIMIT_EXCEEDED: IGMP snooping was trying to allocate more Layer 2 entries than what allowed (15488)This is getting repeated over and...
I had the same issue and it turned out to be my captive portal acl. See below:This ACL MUST be configured on the switch beforehand (some documentation eludes to using a downloadable ACL for this) This ACL MUST contain DENY statements for traffic goin...
I tried to configure this today but ran into an issue - our one ISP uses the ebgp-multihop command. I get the following error when trying to enable the dmzlink-bw command: %BGP: Propagation of DMZ-Link-Bandwidth is supported only for single-hop EBGP ...
I ping'd the ap-manager interfaces on the controllers and then did a 'show arp | inc "IP of interface' then I used the MAC it found for my static arp entry which was 'arp IP MAC arpa'This helped somewhat but we ended up putting all of the AP's into t...
