About amohammed

amohammed · 04-15-2020

Hi Community,I am having a strange issue. When I dial the Auto Attendant Pilot Number I get the following message. Ask your operator for assistance. This is a recording. The SIP integration between CUCM 12.5 and CUC 12.5 is working. I can reach th...

amohammed · 02-15-2020

Hi, Incoming calls seem to be rejected by CUCM based on the CUCM call logs. Outgoing calls work but incoming call don't connect. SetupT1 CAS MGCP to CUCM 12.5 Any ideas would be greatly appreciated.

amohammed · 02-13-2020

Hi, I am trying to upgrade CUCM 9.1.2 but it is failing at the database installation phase. I believe, I am running into the following bug but I am unable to delete or rename the SIP Profiles as they are defaults for the system. https://bst.cloudapp...

amohammed · 01-06-2012

Hello,I have an issue with a 10G link between the Cisco 4900M switch and a 10Gbase-T server nic. The Cisco 4900M switch has a WS-X4908-10G-RJ45 half card installed which needs to be setup to provide 10G connectivity for servers. The link connection...

amohammed · 01-03-2012

Hello All,I have an issue with a Cisco 4900M switch with a WS-X4908-10G-RJ45 half card. The link connection between a 10Gbase-T server nic and the switch does not establish, i believe it is an auto negotiation problem. The link fluctuates constantl...

amohammed · 04-16-2020

The CSS on the voicemail was not set. Updated it and I was able to reach the Auto Attendant. What is the best practice for assigning partitions and calling search spaces for unity (voicemail and AA)?

amohammed · 02-17-2020

The incoming call is connecting now but there is a delay of 10 -15 seconds before the auto attendant picks up. The system plays 10-15 seconds of dial tone before the auto attendant picks up. It is the same if we call an internal phone directly from...

amohammed · 02-16-2020

TAC says it is a T1 layer 1 or 2 problem. The gateway is waiting for a signal from the provider.

amohammed · 02-16-2020

Outbound calls are no longer working. Debug MGCP packet shows call setup failed.

amohammed · 02-16-2020

Yes, most definitely, SIP is the better option. The existing system uses MGCP and to minimize the reconfiguration, I decided to use the same but that seems to have turned out to be a bad choice.

Member Since	‎10-11-2007 09:40 AM
Date Last Visited	‎05-03-2023 05:16 PM
Posts	22

User Statistics

User Activity

Can not reach Auto Attendant via CTI Route Point

MGCP Incoming calls fail

CUCM 9.1.2 Upgrade to 10.x/11x fails

10G Auto Negotiation problem

10G Auto Negotiation problem

Re: Can not reach Auto Attendant via CTI Route Point

Re: MGCP Incoming calls fail

Re: MGCP Incoming calls fail

Re: MGCP Incoming calls fail

Re: MGCP Incoming calls fail