Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a cluster of two ASA5585-SSP60. One Master and one Slave. From NNM the boxes are polled with v3 on their individual interface address in context admin. The Master is OK with SNMPv3 and returns replies, but the Slave says "Authentication Failu...
R1 in AS 65544 is originating 198.18.0.0/24 and that prefix is received to R2 which is running AS 197308(public AS). R2 has a peer in AS 3(upstream ISP) and I would like to forward 198.18.0.0/24 as originated in AS197308 to AS 2.I have tried using ag...
We are planning an upgrade of a few 6500-Sup720-10G from SXJ2 to 15.1(1)SY1. The 6500 systems have redundant Supervisors(SSO) and WiSM blades. ISIS and MBGP is configured for NSF with uplinks on both Supervisors. No linecards (except WiSM).It is stat...
I have struggled for some time with DMVPN tunnels hanging and not recovering. The tunnels are part of a DMVPN where some spokes ara behind NAT/PAT and som are not. The problems only occur for spokes behind NAT. At all times there are no problems init...
I am trying to use the AUX port on a ASR 1002 to connect to a console port on another router. Usually you telnet to port 2000+line number and then you are on the AUX with an outgoing connection. But I can not figure out how to do this on ASR. I am ru...
I also have a C819G-4G-G-K9. Suddenly a few weeks ago the modem got unaccessible with this message:
%PLATFORM-4-CELLULAR_MODEM_SKU_MISMATCH:
and show cellular shows no info.
NAME: "Modem 0 on Cellular0", DESCR: "Sierra Wireless MC7710 4G-G"PID: MC77...
Did you find the root cause for this? I am asking because I have run into the same problem with my 819.
Is there any other way to communicate with the modem and check status of it? AT commands?
I also have an IR809 for testing. It is currently running 15.6(1)T0a and that image has ip sla sender. Also 15.5(3)M1 has ip sla sender present.
Another way to generate interesting traffic is to use NTP. Or sending SYSLOG.
I have no problem activatin...
I am seeing the same message on 3560 after upgrading to 15.0(2)SE6. Before it was running SE5, in which DHCP Snooping was broken, and SE4. Both did not show this messages.The %ADJ-3-RESOLVE_REQ messages is populating the log very frequent. It seems t...
This works! I had read that the feature was for injecting more specifics. But after your suggestion I tried it in my home network and even that I have the same mask on the learned prefix as on the one I want to inject, it works.Tule7640#sh bgp ipv4 u...
