Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Bros!! How to show that a trunk port is in nonegotiate in native IOS switches?? I've configured the port asinterface GigabitEthernet3/9 no ip address switchport switchport trunk encapsulation dot1q switchport mode trunk switchport nonegotiatewhen I d...
Hi guys, I've a few Cisco 7900 series ip phones on my network here. Whenever a call is to a 7910 and the user pick up the handset before the first ring completes the call is terminated. Have anyone encounter similiar problem?? This problem don't o...
Hi guys, I've got an issue after connected to the vpn concentrator, I was not able to login to my domain. Anyone encounter the same problem. The network diagram is below. Internet---VPN Concentrator---PIX---Internal networkI've ...
Hi guys, I've just upgraded a few of my APs with this firmware, after which I lost 2 of my channel. Originally I have access to all the channel from 1-13, but once upgraded I'm left with 1-11. Anyone have face this problem before?Jimmy Seah
Basically, there's a implicit deny any any after this permit statement. Since that's implicit it'll not show on the log. What I suspect is that the packet have a source of 172.16.0.1 which is your loopback. See if you can add another line likepermit ...
I got a feeling that access-list 11 is blocking it. Ddi you do a show access-list 11 and see if it got any hits? Try to take out the access-list from interface vlan 20 and see if it works.
