Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
i have 3 Access points AIR-AP1232AG-E-K9, quite a bit old, but working.
AP1 and AP2 are connecting with a trunk to a switch to separate a Hotspot and a private network with VLANS and MBSSIDs only with there 2,4 GHZ Radios. Now i want a point-to...
Hey Guys, after the Migration from ISDN to a SIP trunk. My 9951 phone don't register anymore. It always say "Phone not registered" But the debug Messages in my CUCME says "Registration successful for 100, registration id is 39" Any ideas?
Feb 25 02:...
Hey guys,
im trying to pretend my internal sip clients and varius dial-peers to register at my external sip trunk.
I always see Register Messages at my WAN Interface. For my sccp phones the no reg command helped.
What can i do for the others?
Patri...
Hello,We use CUCME 8.6 and CUE 7.4.1.Is it possible to use Voicemail on iPhone with Cisco Jabber?IMAP is set up. Users can also view their messages via Outlook. Voicemail settins in Jabber also registered but you can't see any messages. Best regards...
Hello,If I receive a call on a Sip phone (9951), no name is displayed. However, when I look in the local directory, the entries are present. With SCCP phones everything is ok.Do you have any idea what could that be?9951, 7970, 7942 on CME 8.6Regards,...
Edward There are different manufacturers (at least in Germany). Allnet, Zyxel, ....Search for VDSL2 Master/Slave often, pairs are offered. But all have the same units or other enclosures, the chipset etc is the same.Depending on the quality of the li...
Hello,you will need an external 100Base-T4 to 100Base-TX transceiver. I do not know any Cisco device that support this standard. There are several things to consider here also because of the added different ground potentials.100BASE-T4 also supports ...
Hello Heinz,No, it makes no difference in the configuration whether it is with or without a splitter. The card fits for Annex B.You can still force a DSL syncro. method (adsl1, adsl2+, vdsl) with the "dsl operating-mode" command. But you don't actual...
Hello,Are you using the wall socket with a TAE - RJ11 cable and the splitter a original RJ11 - RJ11 cable with small connectors?It is important that the cable is properly plugged in the splitter. The small connector doesn't fit properly and then prod...
