Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys,
Does anyone know what the v·e part is on the following command on Nexus please and how best to remove it? is it default?
snmp-server mib community-map XXXX context v·e (note that the . is actually not a full stop but rather an interpunct...
Hello Guy's,Just wondering if anyone has the definitive answer to my question about recertifying qualifications please:I currently have a valid CCNP which was renewed November 2012 by passing the 'old' Qos 642 exam.I am currently studying for CCIE wr...
Hello,Would anyone know if there were some monitoring tools specifically for Telepresence that are available (preferably free), that can monitor TP calls end to end and alert if the call quality drops below a certain threshold please? I guess similar...
Hello,Just wondering if someone could shed some light on the following scenario please:Nexus 7018 performing 'show ip route' for a particular destination but shows one valid route and two other routes. However the forwarding table only shows the vali...
Hi Guy's,I was wondering if anyone can help me to understand the impact of performing the following actions please? Will I loose remote access and require local console access?- We currently have a number of ACE appliances installed at remote locatio...
Thanks for responding Kirk.
I tried removing the actual command line "snmp-server mib community-map XXXX context v·e" but it was interpreted as "snmp-server mib community-map XXXX context veeeeee" strangely and was still present.
It seems I had to re...
Thank you very much for your help Kanwal. I shall create a new policy-map named slightly differently using the existing class-map and add that to the interface then remove the global policy. Thanks again.Regards,Paul.
