Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all, We're planning an upgrade of our wireless solution from 7.0 Wism based controllers to standalone 5760 controllers, this will allow removal of old 1131 APs, continued use of 1142 APs and installation of newer 1602, 2702 and 3702 APs. Just won...
Hi Folks,A list of all the wireless clients on my WCS shows among other details the protocol in use. I have a mix of 802.11g, 802.11a, some 802.11n clients and another called "Mobile", does anyone know what the Mobile protocol refers to?Thanks in ad...
Hi Folks,I've inherited some 6509s and included in the config is the command;ip flow ingress layer2-switched vlan 10,20I'm not interested in capturing layer two netflow statistics, so was going to remove the command, my question is, is this command d...
Hi folks,I'm having terrible trouble configuring a 5505 ASA for remote access. Its a while since I've done it but I don't remember it being so difficult. Basically, I've followed the Cisco article http://www.cisco.com/en/US/docs/security/asa/asa72/...
Hi folks, I'm having some difficulty setting up a site to site VPN using two ASAs. One side uses a private address configured via DHCP from the service provider. This in supposedly NATed by the ISP so that incoming traffic to our public address is ...
Scott, please see below; there is no entries under Mobility Anchor List, perhaps because Auto Anchor is disabled. This raises another question for me. Without auto anchor and without statically defining mobility anchors (I can't see where these wou...
Scott,How can I tell which is the anchor controller, I have a mobility group but don't predefine which controller is the anchor?Regarding my original question, a little more information that I should have spotted originally. With the clients that ar...
Hi Patrick,Yes, I have NAT exempt rules in place though they may be wrong. I have;access-list outside_nat0_outbound extended permit ip host 192.168.1.251 anynat (outside) 0 access-list outside_nat0_outboundThis is the first address in the pool and I...
Just to add to this, I have a very similar configuraton on an ASA running v7.1 with no problems. The ASA 5505 I'm having trouble with is running 8.2. Does anyone know what specicific to remote access has changed between these versions?
