Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Ive been pretty patient and tolerant of ASDM and Java over the years, however its now at a point where it is impacting my work so severely that something has to change, im sure I am not in this boat alone. I am a managed service provider, and I manag...
Hi, So ive got a couple of external connections configured on an ASA5510...On the Device Dashboard, it no longer shows my "Outside" interface in the Traffic Status graph, its now showing one of my other external connections.How do you choose what int...
Hi UCS community,I was hoping that some of you could shed some light on the cable management arm installation.I have it installed correctly, however it doesnt appear to fit the APC netshelter rack very well with the vertical PDU's installed in the re...
On a UC560, is it normal for a 9971 to re-register itself to the UC every 10 mins?Without fail it happens. Whilst the phone is re-registering it says "Not Registered" and then reconnects.Only noticed this happening after I configured a SIP trunk. So ...
Hi all,Having a few problems with the new software pack compared to the last version. Now, im trying to test the support of the 9971... so thats the new element here... however I seem to be having problems with SIP Trunks here also (perhaps its the t...
Look at it logically. Considering the UC500 is tied to CME, and the new CME versions only run on the ISR G2 platforms. As UC500 is based on an ISR G1 platform, a hardware refresh would be required in the UC500 series.So either a hardware refresh woul...
Hi, very sorry for the late response.Yes... VLAN 100 (voice) is 192.168.100.0/24VLAN 1 (data) is 192.168.169.0/24I have removed the SIP trunk configuration through CCA. However it appears that the re-registration issue still continues.There is no reg...
On pastebin:http://inetpro.org/pastebin/61ab92ac235f4d89bfc6346290a61879I omitted the dial-peers... they arent relevant and just take up too much space.
Yeah the phone registers fine. Then after 10 minutes, it loses registration and then re-registers.The phone log shows:21:43:37 CUCM closed TCP connection21:43:38 No DNS Server IP21:43:38 Updating Trust List21:43:38 No trust List InstalledThen the nor...
No issues with the skinny phones. I cant really take the SIP trunk out...I cant find anywhere a setting that would cause the re-registration every 10 mins.
