HI Friends, I am looking to setup IP SLA to monitor packet loss on by Internet Circuit. if the packet loss on my internet circuit goes above 10% then I want my track to go down and when packet loss reduces to 5% or less then my track to come back UP....
Hi friends, I have a MPLS cloud between sites and i usually send all my internet traffic to data centre as i have a MIS circuit there. recently we took a MIS circuit in AP region on one of our site. we created GRE tunnels to send the internet traffic...
Hi All, I have 4 switches stacked. a port on the second switch has gone in err-disable mode and I wanna toggled that port. my understanding says that I can only do changes on the master. so I went to fa 2/0/2 port on master and shut that down. but wh...
Hi Guys, I am confused about the IPSec Tunnels and GRE over IPSec Tunnel. I know the configuration of both but struggeling to find out the difference in capabilities of these two methods. Please help. Thanks >> VISHAL
HI All,I couldn't find the way for this yet.I am still struggling to create a Track that can send around 10 packets every 60 minutes and if it sees an average 10% packet loss, it should bring my Track down. And once the packet loss average reaches le...
HI benstrauss@imtt.com I have been trying to make a track DOWN if the packet loss to ip x.x.x.x is 10 % or more for 10 minutes and bring it UP if the packet loss goes down to less then 5% for 10 minutes. Can you help me for sample configuration ? Th...
Hi Reza, thanks for the reply.I am sure that I am on the right switch. I struggled with it a lot yesterday. I was shutting down the prot fa 2/0/2 on the paster and was checking on the 2nd member switch for the same port but it was still showing that...
Hi Jennifer, I was looking for the difference in below 2 configs. both can run routing protocols.GRE over IPSec=============crypto isakmp policy 10encr 3deshash md5authentication pre-sharegroup 2crypto isakmp key MYKEY address 153.10.10.1crypto ipsec...
