Hey all,My employer is not facilitating ISE and has asked I convert all our Cisco NAC to RADIUS.I only know what I can find on the net for configuring RADIUS and Im already finding things that dont make sense.The Cisco.com material says config thus:r...
Hey all, I think I am missing something obvious.I am trying to configure failover for my SIP trunks from CUCM to my CUBEs in the event that an ITSP SIP trunk fails.In terms of call flow and layout;Phone <> CUCM <> trunk-I <> CUBE <> trunk-E <> ITSP S...
Hey folks,
Quick question regarding routing on ASAs;
I have a site to site VPN using a crypto map with an ACL for interesting traffic. But do I need to configure a routing protocol to forward the traffic to the tunnel?
thanks,
Paul
Hi All,
Im really losing it with my QOS statistics. I am not seeing the DSCP markings I would expect passing through my switch interfaces and I dont know why.
Ive configured all ports connected to voip phones (non-Cisco) as below. Most have PCs conne...
Hi all, Im trying to figure out if Im being dumb.Im using various 2960 switches throughout the enterprise.I can enter the commands for IOS packet captures in the same way as on my routers. But I never get any output. Im assuming this is because the s...
Great! Works now. Many thanks.It would be lovely if Cisco updated the docs - I was reading the XE-16.6 material which I think is fairly new ?https://www.cisco.com/c/en/us/td/docs/ios-xml/ios/sec_usr_rad/configuration/xe-16-6/sec-usr-rad-xe-16-6-book/...
So that was the missing piece. I did not know that a failed call (path) would cause the RG to search for the next trunk when the primary trunk was still up.All working now.many thanks
Hi Roger, In the event that the trunk-E to the provider is down, trunk-I would remain up, so there would be no re-routing done by CUCM to the second member of the Route Group. As far as CM is seeing, it can still send and receive from CUBE which is t...