Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a couple of Meraki Switches in my topology (MS-130s) both of them. Current version: MS 17.2.1The SW1 connect to SW2 via port 1. I have configured SW01 to be priority 4096.SW01 (priority 4096) via port 1.However, when we are trying to use a Pep...
Hello
I had a switch which had the configuration as
ntp server 1.1.1.1
I have to restrict this so did the following --
no ntp server 1.1.1.1
switch(config)#access-list 20 remark NTP-ACLswitch(config)#access-list 20 permit 1.1.1.1switch(config)...
Hello All
I am tryinging to find where a port (7800) is being blocked withing a section of the network which does not have any firewalls.
Is there any way i can try to find where the port is getting blocked in the network section?
thanks
Hello All I am seeing a issue and would be grateful to have any assistance regarding this. My setup is as follows: Router --> Core SW --> LAN Switch I am trying to gain access to the SH using AUX port -- Router config is interface GigabitEthernet0/0...
Hello all I am trying to restrict VPN access from a couple of subnets on a Cisco Router. The following is the config I have put in but it still allows VPN to establish. Cisco AnyConnect is being used as a VPN ClientRTR# sh run | section ip access-lis...
Thanks Reza for your reply. But if we consider a workstation connected to the port it should always be an access port right? even though the router is configured as encapsulation?
