Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a 4 port etherchannel configured to talk to a 4 port etherchannel on NETAPP server. The NETAPP server seems to be distributing traffic across all the links. The 4507 does not. It appears that traffic is going across only 2 of the for linksP...
Scenario - A firewall with 3 interfaces inside(172.30.1.0/24), dmz(17216.1.0/24)., outside(200.200.1.0/24). A static NAT is created for DMZ server (172.16.1.10) to public IP (200.200.1.10)static (dmz, outside) 200.200.1.10 172.16.1.10 netmask 255.2...
I checked previous discussion regarding this topic and was unable to find a solution. My syslog analyzer was working at one point, but now it has stopped and I can not get it back to a working condition. It appears the Analyzer is running, but not r...
I am just curious why the connection count in the show commands below are so different. The connection count for the rserver assigned to server farm s80 appears to have the highest countwhile the count against the sticky database appears to be the l...
Can someone explain the difference between the two debug netdr commands. SUP 720122-33.SXH5NJSE-425M-1-WAN1#debug netdr ? capture Capture packets into a buffer to show later clear-capture Clear the capture buffer (leaves filters as was)SUP...
The solution is in the aaa login statement.... aaa authentication login whahwhahah line <-- incorrect aaa authentication login default group whahwhahah line <-- correct
I just powered up a 4948E myself and shockingly - tacacs is not working via the VRF/FastEthernet1 interface. I have not seen a working solution in this forum. and suprisingly noone from cisco has posted a response. I have tried both solutions. So...
From the Cisco side, It turns out the output counters on two of the 4507 switchports were not incrememting. Also, the NETAPP vendor identified a bad interface card which was replaced.
