Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am attempting to configure broadcasting from network segment to another. This has been working in the past but since we upgrade some technology (from unix to Windows platforms) it is not working.
Essentially I want UDP traffic on port 3000 which o...
I have two SG500-52 switches which are stacked. I have been trying to upgrade to the latest firmware but it is not working. The boot version is Unit SW version Boot version HW version------------------- -----------...
I have a Cisco SG500-52 (not PoE) switch stacked (2 switches total).The password has been forgotten for the switch. I have repeatedly attempted to access this switch via the console but I am not getting anything appear in the console window.I powere...
Hello,I feel that this should be straight forward but I am having a lot of trouble getting this to work.I am using v8.2 (security plus license) and have an ASA which does the standard allow internal access outside but I also have an additional networ...
I have a client connecting to a portion of my network using AnyConnect. This is working fine, client connects to my ASA5505 and access network resources.What I need to be able to do (for long and boring reasons) is allow the client to "see" the broa...
Thank you for your input.Thankfully I have since discovered that the admin who changed the password must not have done a wr mem as when I rebooted the switch I was then able to login with previous credentials. Phew!!
Thank you for your response. I'm going to rate your answer as correct but there was a line you were missing that I believe was the initial problem all along.What I had forgotten was to apply the access list to the outside interface:access-group outsi...
Ignore me, I'm talimg rubbish. I don't normally set my transform-set like that so it through me.Let's go back to the beginning. Are the ASAs even trying to talk?Run the debug commands:debug crypto isakmp 7debug crypto ipsec 7
This may help you:http://www.cisco.com/en/US/docs/security/wsa/wsa7.0/user_guide/AnyConnect_Secure_Mobility_SolutionGuide.pdfLook at the paragraphs describing WSA and Proxys.In my experience though the cost and time needed to implement solutions like...
