I can NOT get the NPS and Cisco 3550 switch to drop the authenticated user in a VLAN. I have followed this documentation, http://msdn.microsoft.com/en-us/library/dd314181(v=ws.10).aspx that basically says to use these Radius attributes,   Tunnel-Medi...

I followed this document to setup a VPN tunnel with NAThttp://www.cisco.com/c/en/us/support/docs/security/asa-5500-x-series-next-generation-firewalls/112049-asa8x-vpn-olap-config-00.html It works for hosts behind each firewall but I cannot communicat...

I unplug the power, hold the mode button for over 30 seconds while powering on but the system still won't go into rommon mode.  Any ideas how to get into rommon?  Also tried some break key sequences at bootup that had no effect. System just keeps res...

When I try to deploy configuration to my 6509 or 3750 the template creates the following code.  The job fails and when I try to manually input this, the system doesn't recognize it.  Is there a minimum ios requirement or another template that will wo...

DMVPN works fine when I don't have the ASA firewall in front of the hub router.  When I put in the 5505 and NAT the public IP to private hub router IP, I cannot ping from the hub to any spokes inside lan.  The spoke shows encrypt/decrypt packets but ...