Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a problem configuring a Cisco 2504 controller with a backup interface backup configuration, because i can't get the backup dynamic interface to work. I have this configuration:Port 1management interface with backup enabled to port 2 (thi...
I have a 877W router connected to a ISP that offers ADSL2+ connectivity with 20Mb downstream and 1024 upstream. The "sh dsl" command show a 19200 DS and 970 US sync data. The only basic things that I get configured on the router are:- 2 or 3 static P...
Hello,I have a CCME on the 1760 router with 3 VIC installed working OK:Slot 0 - VIC ADSL ISDNSlot 1 - VIC ADSL PotsSlot 2 - EmptySlot 3 - VIC2-2BRI-NT-TEWhen I try to install a VIC2-2FXO on the slot 2, router detects the 2 voice VIC, but only the FXO...
Hello,I'm trying to configure a SSL VPN tunnel via SDM on a 877 Router. The router gets the public IP address dynamically from the ISP, so I have configured the DDNS to access remotely to the router. I would like to know if it's possible to configure...
Hi,I have these dial peers:dial-peer voice 1 pots description trucades al exterior destination-pattern 0T direct-inward-dial port 0/0/0!dial-peer voice 2 pots description trucades cap a movils destination-pattern 06T port 0/1/0 prefix 6I want to bloc...
Hi Scott,Thanks for your answer. I finally found the problem, it is my mistake because the SSID VLAN in the second switch was not enabled with the command "no shutdown"...Br
I finally get it working. I have created 2 bridge groups (no routed), 1 with the atm and the fast ethernet 3 interfaces, (on vlan 10), and a second one with the wlan and the other free interfaces.By this way, the firewall is able to get the public IP...
Hi owillins,Sorry, but this configuration example is only for static public IP, and I need a config example for dynamic DNS or know if it is possible.regards
