Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Scanners dropping out halfway down an aisle, vehicle terminals that freeze at the dock door, and a heatmap that looked fine on paper. These are the most common warehouse Wi-Fi complaints we see, and in most cases the access points aren't faulty. The ...
Teamwork - Network InstallationI've been wanting to write a blog for a little while now on the subject of teamwork. This, of course, is against the backdrop of what we do as a company - network design and commission.For many outsiders, it's a surpris...
Hello,I'm trying to get my router to accept the DNS server sent through from the service provider. I've configured the commands below, which are connecting fine and also getting an IP ok.I'd like to be able to get a DNS server address from the servic...
Hi,Have a wierd issue, where one phone is showing a double phone icon. This appears next to the line button. Normally one icon is shown which changes state as the phone goes on and off hook.This phone has two for some reason - has anyone seen this on...
Hi,For connection to a SIP provider I have several dial peers matching the different destinations.My question is that I only have one VoIP line, so how do I limit several dial peers so that they can only try and use one line at once between them.I co...
HI Maxwel There's a lot more manual handling than you'd ever expect - absolutely right. The amount of cardboard generated is quite incredible - its a major mission to unbox and dispose of all that! It's quite an enjoyable process overall - from the u...
Hi Vincent,Firstly, if you've got a MAC address access list to restrict access, just confirm you've got the right MAC address in there - in my testing it caused exactly the error you've indicated.The other things to try are:Remote end is not powered ...
Hi Vincent,It was quite a while ago now! From memory it was due to authentication.. as I recall it only authenticates on one direction - there were a few configs I found on the net that were incorrect, but from testing I found this to the the case. I...
Hello,You should also consider why your remote sites were put into different areas in the first place. Most likely it was to allow you to summarise at the borders: for example if you have a lot of routing changes in one area they can be masked from b...
Hello,You need to be able to look at influencing both inbound and outbound traffic. I'd take a look at using a route map coupled with a prefix list to apply prepends (for inbound preference) and local preference (for outbound influence).Hopefully thi...
