Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have an unusual situation whereby we are supplying LAN as a managed service but will allow clients to control port security via 802.1X
Although I can get this working fine, we're concerned that there's nothing stopping the client changing the por...
Hi All, I have a client replacing their existing WiFi with a Cisco solution. They currently have a guest SSID with a PSK and have an external proxy presenting an AUP disclaimer page that they have to accept before proceeding - they initially want to ...
Hi All,I'm in the process of designing a network solution for a client and sales have proposed the ASA 5506-X firewall. I have a requirement for a DMZ zone. I recall that the 5505 only supported inside and outside interfaces. can anyone confirm that ...
Hi All,I've just started a project to provide a total wireless solution for a local hospital and I'm intending to do a wireless survey next week to validate the NCS planning tool and do get a better understanding of the environment. This particular h...
I have a site with a large number of AP's and two WLC. I need to do some maintenance on the primary WLC so need to move all the AP's to the secondary controller and I'd like to do this gracefully, without impacting the site very much.I've manually ch...
Thanks Marvin,
That's what it looks like to me too, so I'm just going to have to remove CoA and say "basic auth only
Thanks for your feedback
Cheers,
john
Hi Shahin, I think the problem is the "Default - Internal Users" in your Authentication rule, it's likely hitting that after you've already successfully been authenticated and then it will fail.Attached is my rule - if the condition is met, the defau...
Thanks Vibhor, I've been searching through those data sheets and guides all afternoon but couldn't find anything specifically stating if it had 2, 3 or more configurable interfaces; you would think it would support a 3rd zone but then it is the botto...
Hi Terry, Just wondering if you got an answer to your problem?I am deploying a new solution with ISE 1.3 and I was having a similar problem with my wireless users when I tried to enable it last nightCheers,John
