Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I use macros to configure access ports and voice ports, here is a sample of how it is called.
interface range GigabitEthernet1/0/20 - 24
macro apply cisco-voice $access_vlan 10 $voice_vlan 20
I am trying to call this in an EEM script but am getti...
Hi,I have joined my ACS box to the domain and can auth users in active directory groups. I thought about this somewhat and would prefer to only use AD users in ACS groups. Is this possible, I can only seem to do local users in local groups and AD use...
I am having trouble advertising the client VPN user network via eigrp, below is what I have so far. 10.55.1.0 is not being advertised.router eigrp xxno auto-summaryno default-information inno default-information outdefault-metric 10000 100 255 1 1500...
Hi,I am trying to get DMVPN phase 2 working, I have recently decided to change all of our spoke routers default gateway to go over the DMVPN tunnel back to the hub. I have done this to reduce the admin work on firewall rules to the Internet and have ...
Hi All,I'm facing an issue with two DMVPN spoke sites that have a regular bad Internet connection. When the spokes go down and I get an alert from NOC the outside Internet connection is still up. I have to SSH across the Internet and do a int tu0 shu...
I have recently tried exactly that using two 5508's and a dedicated VLAN as I don't have any RJ45 connections between two campus buildings. Unfortunately it doesn't work, the secondary just reboots several times trying to sync the config and ends up ...
Hi,This is tested on 5.3, but I'm sure 5.2 is the same.You first have to select interactive viewer at the top right so that you get all your filter icons listed at the top of the pageNext you have to left click once in the column you want to filter ...
Hi Minkumar,I am using tacacs and its for admin access of devices.Just to recap, I need to have AD users in a local group and assign that group permissions to equipment. This can somehow be achieved by using ad group to local ACS group mapping?Thanks
Hi minkumar & Pavan,Thanks for answering, I was loosing hope anyone new what I was talking about.. Yes, I am using ACS 5.3 applicance. I cannot find where to set this mapping up.
