Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
We got a Cisco ASA5506-X with Firepower and all traffic is going through the firepower module. There are allot of Access Control Policies allowing and blocking sites.
Now the problem is that the internet speed should be 100Mb but we are o...
Hello,
I have a question what is the best pratice for static NAT and access-list. Example:
web server(192.168.1.1) inside to outside(10.10.10.10) with port 80 and 443.
ip nat inside source static tcp 192.168.1.1 80 10.10.10.10 80
ip nat inside source...
Hello,
I have a question.i'm working on a setup for Microsoft Lync over Wireless and there for we need Qos.
I already created a AVC profile for Qos marking and applied it to the WLAN. but on examing the WLAN Qos settings i can see that there is also ...
Hello,i have a question.I would like to import export routes between VRF's and use OSPF for this.But the difficult part is that i want to do this accross a GRE Tunnel. As below is shown.VRF TEST1 is fully operational and i would like to import TEST2H...
Hello, I got a WS-X45-SUP8-E Core switch with TenGigabitEthernet ports.one of the port on the core give the following error:%SFF8472-5-THRESHOLD_VIOLATION: Te5/4: Rx power low warning; Operating value: -12.4 dBm, Threshold value: -9.9 dBm.The other ...
Hello Swicklund,
it's not quite clear how the switches are connected to each other(on which interface).
but what i can see in the config that you send is that on port 2/0/1 there is no switchport trunk native vlan 254 so it wil use vlan 1 as default,...
