Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Customer has Main Office with MX84 with approximately 30 - 3rd party tunnels to their Clients. They access Client's servers to do support work through these tunnels. The Customer wants to move to a new Office in stages and they want the Staff at the ...
We have a UC560 customer with Software Pack 8.2 installed and they are wondering what, if any advantages there are if they upgrade to Software Pack 8.6.2. I thought there was a good feature Matrix published at one time, but I have been unable to find...
I have a 881W router. I upgraded the router IOS to c880data-universalk9-mz.153-2.T.binand then I upgraded the wireless ap to ap801-k9w7-tar.152-2.JB.tar. I may have changed a few other settings also.Before the upgrade, I could access the wirel...
We have recently replaced three - 10/100 Netgear or DLink switches at a customers site with three - SG 300-10 Gb switches. We are having a bandwidth problem with the connection between two of the switches. The customers says that the connection is s...
Trying to replace 3Com Superstack II Switches (3C16980) with 100Base-FX Modules (3C16970) with a Cisco solution. Existing Fiber connector in Network closet on both ends is an SC connector (picture attached). What Modules, adapter c...
SivaprakasamI talked to the owner on Friday and he says that the bandwidth was faster with the old switches then what it is after I made the change so that the SG100's are working at 100M half duplex at both ends. 1 end is hard coded and the other e...
The working answer for my 881w was to upload the latest software for version 12 and the web interface came back and is working fine, but I want to point out that I needed to also do the troubleshooting as suggested by Leo to arrive at that point. Tha...
