About kylerossd

kylerossd · 11-07-2022

Hello, I have seen some guides for EAP-TEAP and EAP-TTLS guides for integrating with Azure AD ROPC. However, I cannot find any documentation that says PEAP is not supported or supported. Long question short. Can I forklift out using on prem AD t...

kylerossd · 09-30-2022

I have a deployment where I want to learn the MAB username on a Firepower Management Center. I have the FMC connected to AD to pull the users and group, and PxGrid integration completed. I see the passive (AD) and active RADIUS authentications for ...

kylerossd · 08-21-2022

Hello, I have two questions regarding the FTDs ability to have management moved off the management interface to the outside interface. I do not have a FTD 1010 to play with in the lab. In the documentation it says that we can issue the command confi...

kylerossd · 07-26-2021

Hello,I have never had a problem with this before but when I map the image in the java CIMC KVM and reboot the box I do not see a bootable DVD drive from my map. This is a c220 M5 (ISE SNS appliance) Inside CIMC I have switched it between boot mode ...

kylerossd · 05-13-2021

Hello,Documentation seems to be light here. Is it possible to do double authentication using a signed certificate and SAML? The goal would be to authenticate to the ASA with cert, perform SAML auth to the 2FA and authorize the certificate on Cisco ...

kylerossd · 11-07-2022

Never said I didn't. This link does not say PEAP is not supported. However there is a Cisco ISE 3.2 document that does state that Cisco ISE can use Azure Graph API to fetch the user’s groups and other attributes for that user using EAP-TLS. Nothin...

kylerossd · 09-30-2022

Where you able to find a solution by chance? I fail to see how FMC would not be able to see the session as the username of the session is the MAC address of the host.

kylerossd · 07-02-2022

Did you happen to find out if there is support for firepower built into OpenVuln API? It appears only to be for IOS/NXOS.

kylerossd · 06-15-2022

How does one go about this in Cisco ISE? You can do this in the Authorization Profile but not the Authentication... I see no place to apply Framed-MTU in the Authentication process. Identity Sequence, Allowed protocols, etc...

kylerossd · 07-29-2021

Hello Wes,The "solution" was found. Apparently the BIOS is hard coded to accept certain images to allow the mapping of a virtual drive...So if you attached ISE 2.0 (which I needed in this case) the BIOS mapping won't show up. However, if you attach...

Member Since	‎01-05-2009 07:57 PM
Date Last Visited	‎11-25-2022 09:56 AM
Posts	89
Total Helpful Votes Received	47

User Statistics

User Activity

CIsco ISE 3.x PEAP Authentication Azure AD

PxGrid - Learn MAB Authentication Username

FTD 1010 (7.0.1) Outside interface management

Boot for vKVM-Mapped vDVD1.22 not in menu

FTD - AnyConnect Certificate & SAML Authentication

Re: CIsco ISE 3.x PEAP Authentication Azure AD

Re: FMC learning MAB authentication via pxGrid ISE?

Re: OpenVuln API for Firepower

Re: Radius Framed-MTU attribute

Re: Boot for vKVM-Mapped vDVD1.22 not in menu