Fab. I'll attempt the upgrade today and write back with any details. As it stands now phones are sti...

HI all, The SSL certificate on our ASA pair has a "common name" like PhoneVPN.myCompany.com in the c...

HI All, I've installed this OVA onto ESXi 6.5 and there were no errors during the process. I notice ...

I do have a case open and I reported it there as well. In the interest of letting people who might a...

Symptom: Calls between an MX300 G2 running CE8.1 and several different TX1310 immersive units would ...

Thanks for the response. I should have mentioned that this location uses a Callmanager Express (CME)...

All, Below are errors from a Q931 debug for a Vz PRI circuit. caller ID that we place on the line us...

In CUCM go to Device --> Phonesearch for the phone you'd like to make Caller ID changes onUnder 'Ass...

Yes, jitter is very high with max jitter often above 1000ms. For some reason when I do an extended p...

This issue is now resolved. Removing the codec entries under DSPFarm and replacing them fixed things...

Community,We're currently running a c20s codecs (software version 5+) in conference rooms and they'r...

Hi folks, did you determine what was causing this issue yet?We have a similar problem but it's only ...

I have been using the guide at Peter's CCIE Musings and Rants (now in colour!): Cisco ISR G2 Video C...

Hi all,I setup a new office in Los Angeles and since there's only a few people there we couldn't war...

(view in My Videos)