Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am struggling to get this right. I need to let my call manager send out external phone mask. I see the right digits being sent using 'deb voip ccapi inout'. I have removed 'translation-profile outgoing PSTN_Outbound' from the outbound dial-peers...
I had posted this before, but can't seem to find it under these new forums. I have a CME that the CFWA feature was working when service was POTS. They changed to PRI and it has stopped. Call trace from the carrier shows that on CFWA they are recei...
I have a customer that is currently on an Avaya system.There is an attendant/call handler for automated conferencing. Attendees dial a DID, the attendant asks for their conference (810 + #), then their attendee ID (810810#), then they are placed in ...
I am assisting with CME 7.0, the site users want to use CFWD, but the call either responds with fast busy or call can not be completed as dialed. If I have the user dial the number directly it dials out and the call connects.If they press CFWD on th...
I have not had much luck searching appropriately, and I'm hoping someone may have a configuration they can share.I have Catalyst switches and 2811 routers that I need to give the client IT Director access to. I want to give them their own credentia...
Chris,I am aware of that. The carrier will allow the numbers.For example, I changed - rule 1 /.*/ /4082879919/ (main line) to - rule 1 /.*/ /4084596499/ (DID on circuit) and the outbound caller-id would show as 6499.If I remove 'translate calling ...
Does this mean a correction on what I'm sending to the Telco or they need to correct what they are receiving?This is a CME 2800 Series router with a PRI connected. There is not a separate cucm.
No luck. Still says, "Call can not be completed as dialed".chrs-phx-cme#sh loggSyslog logging: enabled (0 messages dropped, 10 messages rate-limited, 0 flushes, 0 overruns, xml disabled, filtering disabled)No Active Message Discriminator. No Inactiv...
The call is IP to IP (107 > 123), but when CFWA is invoked it goes to 602XXXX403 (XXXX are just missing digits, I was asked to not show the full number).Attached are results from a call trace with the telco. It appears that the telco is receiving 3 ...
