I am interested in adding some equipment to my R&S lab to train voice scenarios. My question is what is the consensus on the best way to run the necessary apps (CCM, Unity, ETC)?? I was thinking VM Ware. Also where do you get the apps? Do you hav...
I hve a question about diaer load-threshold. I know if the command is issued using a 1 as the load all b channels are intitialized and do not flap aslong as there is interesting traffic. My question is what if the command is not issued at all What...
Someone please correct me if I am wrong but if you add the 5 minute offered rate for all your classes you are classifying about 175K worth of traffic throughout your service policy. If I am reading correctly your circuit is 256 up 1M down. From loo...
There is an EMI image for the NME Module. If you reguire OSPF then you must get the IP Services or ADV IP services. Try searching for "c3750-advipservices-mz.122-25.SEE" The IP base EMI doesn't support most of the routing protocols but does support ...
After working through this issue myself I have come to a few conclusions. 1. Cisco did not intend for this switch module to be used with a layer 2 link to the router.2. You can't configure a trunk encapsulation on the g2/0 interface and subinterfa...
Greetings,I would like to revive this thread with a slightly differnet scenario.The objective would be to extend VTP protocol traffic across layer 3 links.The current configuration (testing) is 2 vlans (3750s) utilizing ISL trunks to sub interfaces (...
It looks to me like your router hostname "udvmum" has a default route pointing to the local Fa0/0 interface and you have no default/static route with a lower admin distance pointing to your other site. You have a default route going out the serial i...
