Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I install upgrade my call manager from 6.1.3 to 7.1.3(b).everything working except firmware 7940.It's strange because ip phone 7940 don'r accept any change on call manager, for example if I change alert display, the change is not replicated on th...
i think that digit by digit it's the problem.
only for test, can you set the right number in destination pattern of you dial peer pots
example
dialpeer 100 pots
destination pattern 09015497458
forward digit all
voice port etc etc
ok sorry for mistakes
Are these simply FXO lines with one phone number for each, or FXS/DID DID lines?
sorry but not understand...
can you explain your scenario that works and not works?
thanx
