Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
If i have a 50 Meg pipe for my wan and I have X amount of data that is tranmitted over the circuit a week, how do I calculate the amount of data that should be reserved for that traffic. The traffic include voice. I know we can use a LLQ. I am cur...
I am looking to create a profile for VPN users in ISE 1.2Are there any best practices or articles that can be evaluated to determine how I can go about profiling vpn users?
I have an ASR 1001 router. I have enabled flexible netflow with the following commands belowflow record AAAA match interface input match interface outputflow exporter BBBBB destination 10.10.89.71 vrf Mgmt-Intf ---->this is the Ip address of my Or...
I am running Cisco ISe 1.1.2. I have many iPhone users that connect to wireless. I have installed a Godaddy cert on my ISE administration server. I can not get the iPhones to trust the cert. My Androids accept it. Any ideas?
I see exactly what you are referring to. I really appears that when you switch a characteristic/location of the image does not immediately reflect the changes. Leaving you sorta confused. But I was informed that if you save the config you can then...
Thanks Collin,For clarity purposes, I am looking for something that says the rsa key is 2048. Your output indicates 1024 bits. If my rsa key is set to 2048 what show command(s) indicate this?
Hello Tarik,I have seen the first link. Many have been pointing me in this link. While the phones are on the compatibility list I still continute to get the following error message. "Can not rust the GO DADDY ROOT Certificate." With this error mess...
