Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,The requirement I have is for calls to a phone number to not go to voicemail during the working day but just keep on ringing, to go to voicemail after x rings between 18:00 and 20:00, and for nightservice to be used after 20:00.We have this workin...
Hi Sriram,Thanks for the suggestion but unfortunately I don't believe that will achieve the required result either.What is required is that during the daytime there is no attempt to transfer the call to voicemail, with the phone just ringing until ei...
Hi Jarek,If there is no ISDN service where the remote site is then you will have to forget about using ISDN backup from that particular site.Your best way to get dial backup would be to use something like a WIC-1AM or WIC-2AM (analog modem WICs) at t...
You need to use the 'distribute-list in' command under IGRP with an access-list to block the route from being entered into the routing table by your router. For example, first create your access-list:access-list 1 deny 66.0.0.0access-list 1 permit 0...
The router will build its routing table by taking all the matching routes with specific masks and then selecting those with the lowest admin distance. Finally, it will use cost to select the preferred route(s).It is quite possible for you to end up ...
