Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My intention was to create Mobility group between WLC 2504 @ HQ and 2100 @ remote office.Configure identical guest ssid on both WLCsTunnel guest ssid traffic to the WLC 2504 which has an interface in DMZ zone.Note: WLC 2504 lives in subnet 172.17.x...
intend to add a second controller and I was wondering how I could handle for instance,the MAC address filtering database. Will I have to add every MAC address to both WLCs or is there an alternative wayNote: I will be configuring mobility group so as...
I am planning to configure separate VLANs for voice and data on my network,VLAN 2 and VLAN 3 respectively.At distribution layer I have a single catalyst 2960S TS Switch.At access layer I have catalysts 2960 TC for data and ESW520 Poe switch for sip p...
I am planning to configure separate VLANs for voice and data on my network,VLAN 2 and VLAN 3 respectively.At distribution layer I have a single catalyst 2960S TS Switch.At access layer I have catalysts 2960 TC for data and ESW520 Poe switch for sip p...
Am using the SLM 2048 as my core switch in a small environment,for distribution switch I have ESW520, SRW2048,catalyst 2960 and another SLM2048.Each of the distribution switches has a single link to the core.Prior to deployment I configured a managem...
Hi Rasika,Thanks, i noticed a wrong IP address for WLC1 under WLC2 mobility settings. Mobility status is now up up on both WLCs.Second Challenge has to do with internal dhcp on both WLCsAre my to to use a single internal dhcp on the Anchor controlle...
Thanks a lot for the insight,but I have another question.Will subsequent change on one WLC replicate to the other ?Sent from Cisco Technical Support iPad App
