HI, I am trying to enable BGP dampening on the router. It works with the default parameters. But does not get enabled with following parameters. Please suggest. bgp dampening 5 750 2000 7. Message I get is "%dampening is not enabled for base" Regards...

Hi All,It might look funny but it would be great if someone can help me with Cisco command equivalent to juniper command"set community members bandwidth" or alternate method to implement the same.Regards,Bhavesh

Hi Friends,I have done a test setup of IPv6 on NAT using ASA5545(9.1.1). I am NATing external IPv6 to a pool of IPv4 and internal IPv4 to public IPv6 using static NAT. The basic connectivity is established and workng fine. We would be checking the ap...

Hi,I have 7206 VXR with VAM2+ card. I am seeing close to 4500 IPSec conenction with the router. The traffic is low and utilization is below 10%. I am just wondering is it an alarming condition since the router is touching the documented tunnel capaci...

Hi All,I ahve a requirement to configure static crypto for 1800 site and I need to configure on two sepaarte interfacs at spoke site which means I need to configure 1800*2 = 3600 peers at central site. The challenge I have is due to load balancing , ...