Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just setup Jabber (9.0.2) on iphone with Mobile Connect (CUCM 7.1.5). I run into incoming call issue where both Jabber & mobile phone would rings about the same time. I did some of research and Cisco doco below state Mobile Connect should automatical...
Hi Everyone, Does anyone know or implemented Microsoft NLB setup on Nexus 5K? I could not find any relevant doco state that Nexus 5K could support this Microsoft NLB functions so far. Base on the N5K CLI, I can manually defined static mac address tab...
Hi, Does anyone know the correct way to configure a voice port on Cisco 3550? Cisco seem to use different config on every switch family.. it is a bit confusing.. eg: Voice vlan:100 with 802.1Q Frames, data vlan: 50. it this the correct config?? ! int...
Does anyone know how the multiple default-routers work? According to Cisco we can specify up to eight addresses in one command line. eg:default-router address1..address2...address8 I have tested on my lab with WinXP. I can get more then one default-g...
Guys,I am having some difficulty to understand the SSM boundary config sample from this Cisco doco. eg 1, I am not sure why they have the host 0.0.0.0 line. Also the acl are base on ip, udp and igmp? Eg 2, similar to eg 1 but it also has deny pim. C...
Kenny. thanks for your reply. We do have N7K and N2K in our data centre with ToR setup to minimize cabling and patch panel to server racks. however, one of our racks have Cisco 3900 WAN router and few ASA firewalls. The dilemma I have now is how to c...
Hi Alex,Could you please explain what do you mean by "Do NOT extend the downstream device topology". Could you please point me to some doco or links as well? we were planning to connect a wan router to n2k recently until I saw this post.Regards,Sean
Hi Amit and Jerry,Need your input on Router connected to N2k. I understand the N2K is design for end host connection rather then connect to other downstream switch which may cause some issue as Jerry and you mention on above post.Do you see any issue...
N5K is Layer 2 access switch and do not support ip routing. Therefore, static arp for MS NLB configuration are optional on N5K.I believe you must have N7K or 6500 or router act as default gateway for that MS server subnet which connected to N5k. You...
Static mac address config cli from cisco docohttp://www.cisco.com/en/US/partner/docs/switches/datacenter/nexus5000/sw/command/reference/rel_4_1/ethernet-cmd-ref.html#wp1378254
