Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have an issue where I'm seeing output discards on pretty much all my ports configured for QoS. The switches are cisco WS-C3750V2-48PS running 12.2(50)SE1. There are four switches stacked using stack cables. The QoS implemeted was auto-qos...
Hi all,Having an issue with the ip pim rp-address x.x.x.x <access-list> override command. I want a specific mulitcast group to use the loopback address of the local first hop router as its RP instead of the auto-rp learned rendezvous point address. T...
Try to make port 2 a trunk instead of tagged. The wording is a little confusing with this device as tagged, to me, means a dot1q trunk, regardless of how many vlans on it.Did you make sure to make the WAP port a trunk(tagged) as well for both vlans?
You can connect your pc/laptop to ethenet port 0/0 and assign IP address 192.168.1.2/24. After that, just telnet to 192.168.1.1.Make sure to set up the vty lines to accept telnet as well as assign an enable secret via your console session.
Sounds like mac based port security is enabled. I've never worked on the Catalyst 520 but there must be a config section under security. However, be very careful connecting switches to other switches. An Ethernet loop can ruin your day.
My suggestion is to take screen shots of all your config screens as well as do a config backup of each device you are making changes on. If all else fails, you can return the config to its previous state. Also, a good idea is to verify which devices ...
Ok. In this case, you shouldn't have to configure anything from a VLAN perspective on the dedicated Internet port as it should be isolated from the internal switch.So, if we were to look at it from an Layer3 point of view, you could view it this way:...
