Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good Morning,A customer has a Publisher-Subscriber cluster with CUCM 11.5 installed. Recently he wants to change th application password and as requested, I did so in CLI access with the command " utils reset_application_ui_administrator_password". I...
Hello,
I have an 11.5 and 7.1 CUCM clusters, the 11.5 is new and will be replacing the 7.1 cluster, however, I need to comunicate both clusters. I am able to call from 7.1 cluster to 11.5 cluster, but now from viceversa. In the RTMT call process i s...
Good afternoon,
I have two 8941 ip phones connected to a 9.1 CUCM on a BE6000 as SCCP phones. I have other models and they all show the right time given by the NTP server, however, the 8941 phones are 21 minutes fast than all the other models.
The ...
After applying the device pack for CUCM 9.1 in order to be able to register an 8811 phone, only at the 7965 model, the missed, placed, received calls directories don't show any information, other models yes.
When selecting missed or received or place...
I had support from Cisco TAC and I was able to upgrade my 2802i access point. What I needed to do was the download 8.5.182 ME firmware and perform the following command on the AP: AP# archive download-sw / reload tftp://tftp-ip-address/image filename...
Hello, I have an 2802i AP working as a controller, actually all the APs, 16, are 2802i. The all have the release 8.10.151. I connect this AP to the Network, it is viewed by the ME controller, I try to upgrade it from the controller, but it says it ca...
Hello, I found the problem, it was my solar winds server that was trying to access to the CUCM with a password that we modified and didn't update on the solar winds. A workaround I did before finding the problem, was to change the application passw...
Thanks for your reply! I found another NTP server at the same LAN this phones are. I was added recently for testing and it was over time.
Thanks for your time and support.
Thanks Aman, after adding 0 to Idle Timer (seconds) option, now I can see the missed calls, however, if I try received or placed calls, it keeps showing "Select Service" at the bottom of the display.
Any suggestion?
