Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I hope someone will be able to assist with the Anyconnect VPN issue that I am having at the moment.
I have 2 Cisco routers onsite. One is Cisco C867 and another one is Cisco 887 (old router used for internet and Anyconnect VPN).
The in...
Hi all,
We signed up for a NBN FTTN 100Mbps plan with iiNet with no contract.
Purchased a Cisco 867VAE-K9 outright from another supplier.
I've been trying to configure the router to work with NBN, but it doesn't seem to like it.
I used the sampl...
Hello all, I am currently having issue with Cisco 7931 phones not getting any IP which is located in their workshop (It's a donga and located 20 meters from main office). Here is the scenario:VLAN 1 - 192.168.28.x/24VLAN 100 - 10.2.1.x/24In the main ...
Hi all,
I configured Anyconnect VPN on Cisco 1811 router. But, for some reason, I am unable to open the VPN webpage. It's comes up with 404 not found error.
Below is the snippets of the config from the router:
aaa authentication login ciscocp_vpn_xa...
Hi there,
One of my client has got a cisco 7931 phone sitting on their desk. Their main phone system runs on Cisco UC560.
Below is the the picture of the phone.
Basically, we want to view the missed calls on this phone. But, for some reason i...
hi... Did you find the answer on how to change the read-only mode to read-write? My switch is busted and goes into Rommon mode everytime I boot. I just need to know how to enable read-only mode on the switch so that I can copy an image to the Flash.T...
Thanks for the reply everyone. I found out the issue. It was with the switch configuration. Switch had both VLAN 1 and VLAN 100 configured. I had to remove VLAN 100 from the switch. Once removed, the phones got IP address and started working okay.
