Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I am working to deploy a group of 1242AG APs with a 4402-12. I am looking to use LWAPP and run the WC in layer 3 mode with the APs deployed on a different subnet.I have been trying to allocate an address (and DHCP option 43 for the WC management I...
Hi,Can anyone enlighten me as to the 80GB minimum disk space requirement for Cisco Works LMS 2.5. i) Why is this required? and ii) Could I get away with a lower disk capacity i.e. 36GB?Many Thanks,Jon
Hi all,Thx for all your replies. I am afraid to say the problem still persists. I have tried the following configs.option 43 hex f1:04:c0:a8:01:c8&Option 43 hex f1:04:c0:2e:a8:2e:01:2e:c8 Both of these have no affect on the APs even though I can see ...
Hi,Thanks for the quick reply.I am using the management interface address of the WC. I am using a 1242AG shipped in LWAPP configuration. The setup documentation appears to indicate I need to use a TLV value.I have tried using an ascii string however ...
Hi,I am currently having a problem with providing DHCP option 43 to my AP's. I would certainly be interested in this white paper as info is short on ground. Let me know where I can collect it from.Thx Jon.
Hi,I have seen this problem before (as I guess most other VPN admins have). You will need to check the client configuration and the group setup on your concentrator. You will need make sure the transparent tunnelling option is selected and set to IPs...
I think you are talking about a hunt group. You simply give your telecommuters a single number and this can be logically associated (in the PBX or in the carriers network) with a number of POTS lines connecting into your analogue router ports.You can...
