Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi ACI experts,
I would like to know is EPG filtering logging can be seen the details(allowed/denied) for the src-ip and dst-ip?
I have plan to move some servers from conventional switch to the ACI switches for better access control. Initially plan i...
Hi All,
Quick question, i've provided with read-only access to routers which managed by 3rd party, i can't do "show run * " command from the routers. But i try to figure out the current routing(OSPF) setup. I saw the OSPF link cost is being manipula...
Hi Switching Experts,
I got a continuous error pops up from logs as below.
%IPC-SW1_STBY-5-WATERMARK: 6580 messages pending in rcv for the port Card22/0:Request(3060000.C) seat 3080000
I found some discussion on this forum and the resolution is ...
Hi Security Expert,
I got a VPN client office using 192.168.14.0/24 network. Once they established the Anyconnect vpn connection to the main office, they're unable to access to their own local 192.168.14.0 servers and printers. I've check our VPN sp...
Hi All,
My switch is generating the logs below and it triggered alerts to our monitoring system. CPU were looks alright and it doesn't reach our threshold. Had tried to reboot the switch but this still happening every 2-3 days with unknown reason, t...
Yes... that is correct. I meant this statement "ospf cost should be applied to both ends of the link for it to work correctly". This is not a correct statement becoz you need not applied to both ends to work "correctly", it depends on your design req...
Thanks Mark,
I just read more about OSPF cost and got my answer. Your answer is partially is correct, you need not to applied at both ends of the link to work correctly, you can do 1 end default cost and another end cost 300 to influence the route se...
Hi Rojer,
I got the similar error logs issue that logs every few minutes, but mine's is happening to Card22/0. May i know how you relate your Card5/1 to the physical interface/module? I couldn't relate my Card22/0 to which module from my system and i...
I tried not to open TAC because we got limited case can open, and i missed the show-tech captured during the dropout so i got nothing to show TAC now, the network is working fine now and i'll expect the dropout happens again on the application openin...
