Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am working on getting ISE licensing requirements put together for the upcoming budget. I am confused on licensing for a failover appliance. Do we need to get another set of licenses for the failover appliance, or will the licenses for the primary d...
I have two 2602i that are no longer booting after they joined the controller and pulled the updated image. from the console this is what I see during the boot process.IOS Bootloader - Starting system.flash is writableFLASH CHIP: Numonyx Mirrorbit (0...
We recently went through an upgrade in which we replaced all of our brocade pass through cards in our Dell chassis with new Cisco 3130x switches (stacked). After installation we've had 2 rather strange issues over the last month post installation. 1)...
About an hour ago I had the master switch on one of my 3750x (WS-C3750X-48PF-S) stacks crash. The only two items we've found that could have caused this issue are the roughly 1.3 million big buffer misses and several of the following in the syslogSLT...
I am currently receiving the following syslog warnings from one of my 3750-X stacks: Feb 8 18:04:31.475: %PLATFORM_STACKPOWER-4-CABLE_A_CURRENT_OUT: Switch 1 stack power cable 1 outward current is over the limitFeb 8 18:04:31.475: %PLATFORM_STACKPO...
Thank you both for your assistance. This seems to have done the trick for one of them. I am going through the process for the other one that was giving me issues.Is there a way I can tell from the part number or serial number as to how these shipped?...
Hi Sandeep, I updated FUS on the WLC and attempted the reset as described and this is the output I am getting from the AP now. IOS Bootloader - Starting system.flash is writableFLASH CHIP: Numonyx Mirrorbit (0089)Xmodem file system is available.flas...
I pasted the boot process for the AP in my original post. The AP won't complete boot so there is no way for me to issue the "show inventory" command to it. Here is the output of "show sysinfo" from the WLC:(Cisco Controller) >show sysinfoManufacturer...
