vvijaysa

Hey Daniel,Is your internet connection via a VPN Tunnel? If yes, try enabling NAT transversal.Thanks...

Hello billetj01,What firmware are you running? We have had similar problems with old firmware. I gue...

Hello Thai,I assume your post is similar to the below posthttps://supportforums.cisco.com/message/40...

Hey Kevin,Will you be able to share your topology so that we can see more detail. Thanks Vijay

Hey Thomas,As the ping test went well, I assume may be it is a DNS problem. Check your DNS settings ...

Hello Ross,Try power cycling the device. If the problem remains, please contact SBSC support for fur...

Hi Shereef,FYI, all ports od SG300 are L2 ports. The only way you can do is Inter-VLAN routing. SG30...

Thanks for the update Michael!Sent from Cisco Technical Support iPad App

Hi Michael,NSD fails means Network service detection failing on wan2. Under the dual wan settings, c...

Hello Michael,Don't worry about the keep alive option? It is with PPPoE only. Can you swap the wap1 ...

Hello Michael,I think the WAN2 connection has gone idle. What kind of connection you have in wan2? P...

Hello Tomasz,Yes. I guess you need to connect all APs to the switch (same bridged network). Clusteri...

Hello,I think you can connect the switch through the router's wan port and set the switch's IP addre...