Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are running Cisco TMS version 15.13.3 and its running very well and has for many years.TMS Login/Authentication is using IIS and Integrated Authentication to use our company login credentials for TMS Login.Recently there has been a push for MFA (M...
We are running TMS 15.4 with approximatly 800 endpoints.
These endpoints are a mix of MXP, C Series and MX series.
These end endpoints are either SIP only of Dual (H.323/SIP) registered.
Corp Directory works great on all endpoints from both the handh...
We have a C40 running TC7.2.1 that is SIP/H323 registered to a VCS running X8.5 (No CUCM)The system does not have Multisite, but we want to use Multiway (we have Multiway working on other endpoints)I'm using the call control portion of the web interf...
Does anyone have a good set of instructions on how to do a full packet capture on an MXP endpoint.I would love to do something that I can open directly in Wireshark. We are looking to verify that the DSCP markings are being sent and received on the U...
Thanks Wayne, I do not think I asked my question clearly, my question is:Can systems that are running the latest CE software be managed by Control Hub?We know that TMS has reached end of life and we still have 100+ systems that run CE software to man...
Yes, we have found a replacement fan from an electronics wholesaler call Digi-Key
They have EVERYTHING electronic or connectors, however "Some assembly required"
The fans come with just bare leads (No connector)
Parts are :
Fan = Digikey part # 3...
We have also seen some stubborn endpoints that do not seem to want to to NTP sync...
We typically use the IP Gateway address as the NTP source
My understanding is that any Cisco IOS device (Router or Switch) that is "in NTP sync" can be used as an NT...
