k-baba
Level 1
Level 1
Member since ‎07-24-2003
‎07-31-2024

User Statistics

  • 46 Posts
  • 2 Solutions
  • 6 Helpful votes Given
  • 0 Helpful votes Received

User Activity

I want to use C1111-4P as terminal server for other router's console port. I found past discussion in below, and I tried to make it, but not successful. (attached is current config) https://community.cisco.com/t5/other-network-architecture-subjects/i...
C1111-4P has only one serial port (con 0) I tried to use the port for accessing console of another router, but telnet is rejected. #telnet 10.10.10.10 2000Trying 10.10.10.10, 2000 ...% Connection refused by remote host 10.10.10.10 is loopback of C111...
I am firstly setting up C9800 , but AP join is not working and stays in "ap auth pending".DTLS session is established by checking "Monitoring -> Wireless AP statistics -> Join statistics".I tried adding AP mac address in "Tags-> AP -> Static" , but i...
I configured ISATAP between two routers.[Server cisco3845 ver 15.1(4)M12a]interface Tunnel4 no ip address no ip redirects ipv6 address 2001:22:33::/64 eui-64 ipv6 enable ipv6 nd cache expire 10 no ipv6 nd ra suppress tunnel source Loopback0 tunnel mo...
2台のルータ間でISATAPによる接続を行っているのですが、show ipv6 neighborsの結果がIOS 15.7(3)M4aの機器では表示されず、IOS 15.1(4)M12aの機器では表示されます。IOSバージョンによってtunnelインタフェースでのneighbor表示の仕様が異なるのでしょうか?
Community Statistics
Member Since ‎07-24-2003 08:37 AM
Date Last Visited ‎07-31-2024 07:01 PM
Posts 46
Helpful Votes Given To